Search:

Type: Posts; User: binhe615

Search: Search took 0.01 seconds.

  1. I think you just need to change the offset...

    I think you just need to change the offset extruded family so it extrude horizontally.
    Also I would recommend you not using any void if possible. You can just use solid in this case....
  2. Replies
    5
    Views
    1,627

    Did you set work plane before you draw the 2...

    Did you set work plane before you draw the 2 reference lines on the sides?
    you just need to set the work plane on the main reference line.
  3. Replies
    1
    Views
    732

    Are they supposed to be hidden by that panel? I...

    Are they supposed to be hidden by that panel? I think this usually happens when the thickness of that panel is very thin. Will you see those lines if you print to PDF, or print?
  4. Replies
    5
    Views
    1,627

    Fixed it but I only have Revit 2020. There might...

    Fixed it but I only have Revit 2020.
    There might be other methods but here's what I did:
    Instead of using Lined based detail template, I just used the detail template.
    1. Draw a reference line...
  5. Replies
    1
    Views
    1,345

    Build can probably build in some dimension...

    Build can probably build in some dimension parameters so you can control it in your project.
  6. Replies
    12
    Views
    6,119

    37677 I had a try and no extra lines shown up....

    37677
    I had a try and no extra lines shown up.
    It's probably because of the way you create the glass form.
  7. Replies
    17
    Views
    2,772

    Something like opening width=if(sidelight,door...

    Something like
    opening width=if(sidelight,door width+sidelight,door width)
  8. Change the view discipline.

    Change the view discipline.
  9. Method 1 is to use Tab to select a close loop of...

    Method 1 is to use Tab to select a close loop of lines and HH to temporarily hide them, you will probably find the extra line sitting around.
    Method 2 is to select all the lines, you might be able...
  10. Replies
    5
    Views
    2,997

    Maybe just place 6 points and create the faces.

    Maybe just place 6 points and create the faces.
  11. Create an integer parameter and type in the...

    Create an integer parameter and type in the formula, then select the array and link the parameter.
  12. Replies
    11
    Views
    4,798

    Make sure you back save your skechup file, use...

    Make sure you back save your skechup file, use Link Cad and link it into an In-place Generic Model.
Results 1 to 12 of 12