Results 1 to 1 of 1

Thread: U-Trap for HVAC Equipments

  1. #1
    Member RAJESH87's Avatar
    Join Date
    July 19, 2014
    Location
    CHENNAI, INDIA
    Posts
    95
    Current Local Time
    06:23 AM

    Not allowed! Not allowed!

    U-Trap for HVAC Equipments

    Hi Folks,

    I try to create a family of U-Trap but not fitting in the project correctly. I

    For Information: created it in PIPE FITTING category under the Elbow.

    i attached snap shots, while in serting in ptoject it comes correctly, but when i connect to the pipe it is going reverse can anyone give any suggestion on this!!!

    Thanks!!!
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	snap shot-2.PNG 
Views:	26 
Size:	8.1 KB 
ID:	19763   Click image for larger version. 

Name:	snap shot-1.PNG 
Views:	28 
Size:	15.6 KB 
ID:	19764  

Similar Threads

  1. Functional P-Trap
    By Fishtail8 in forum MEP - General
    Replies: 23
    Last Post: October 24th, 2018, 01:49 PM
  2. P-trap
    By Jimbob in forum MEP - Family Creation
    Replies: 3
    Last Post: December 29th, 2015, 02:38 PM
  3. Offset Sink Trap
    By cellophane in forum MEP - General
    Replies: 3
    Last Post: May 17th, 2012, 05:45 PM
  4. Connect Equipments to one system
    By Ghassan in forum MEP - General
    Replies: 1
    Last Post: November 29th, 2011, 11:48 AM
  5. Speciality Equipments families missing in Revit MEP 2011
    By prawin92 in forum MEP - Family Creation
    Replies: 2
    Last Post: August 11th, 2011, 12:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •