Показано с 1 по 3 из 3

Тема: inserting reference point in family to ease alignment in model

  1. #1
    New Member
    Регистрация
    08.09.2017
    Сообщений
    1
    Местное время
    03:25

    Not allowed! Not allowed!

    inserting reference point in family to ease alignment in model

    I am a Revit newcomer. Many, many years with AutoCAD and some with Solidworks.

    I want to add an "insertion point" or "reference point" to a family to allow easy alignment in the model.

    My specific situation is I'm trying to constrain/lock/confine steel columns with corresponding concrete foundations. I want to add a point at the center of the top of the foundation family that will allow snapping and locking to the center of the bottom of the column.

    Or perhaps there is a better approach? Thank you.

  2. #2
    R.I.P. Аватар для MPwuzhere
    Регистрация
    14.12.2010
    Адрес
    Las Vegas, NV
    Сообщений
    4,864
    Местное время
    02:25

    Not allowed! Not allowed!
    That is what Reference Planes are for... You can modify which reference plane establishes the origin point by selecting the planes and checking the Origin box.

  3. #3
    Member
    Регистрация
    18.05.2011
    Адрес
    Calgary, AB
    Сообщений
    431
    Местное время
    03:25

    Not allowed! Not allowed!
    This might get a quicker response in the Structural - Family Creation forum. Best of my knowledge, columns are tied to the levels. For foundations above or below a level, pick the closest level and adjust the base and top constraints of the columns. You can lock them to the top of foundation, but the second you change the top elevation, Revit throws up a warning about constraints not satisfied.

Похожие темы

  1. Creating Alignment Reference in a Family
    от itisntmakingsense в разделе Architecture - Family Creation
    Ответов: 7
    Последнее сообщение: 13.12.2016, 18:53
  2. Inserting linked revit model
    от redmonki в разделе Architecture and General Revit Questions
    Ответов: 4
    Последнее сообщение: 27.01.2016, 09:40
  3. About Reference Point
    от thaihoalu в разделе Architecture - Conceptual Massing and Adaptive Components
    Ответов: 3
    Последнее сообщение: 22.11.2014, 12:53
  4. Nested Family Issue with alignment after inserting into project
    от Stonehands в разделе Architecture - Family Creation
    Ответов: 7
    Последнее сообщение: 12.03.2014, 16:26
  5. inserting Point CLOUDS - how ???
    от kunster в разделе Coordination Tools
    Ответов: 13
    Последнее сообщение: 31.05.2013, 16:30

Ваши права

  • Вы не можете создавать новые темы
  • Вы не можете отвечать в темах
  • Вы не можете прикреплять вложения
  • Вы не можете редактировать свои сообщения
  •