Results 1 to 6 of 6

Thread: Arraying

  1.    #1
    Junior Member
    Join Date
    September 28, 2017
    Posts
    26
    Current Local Time
    06:23 AM

    Not allowed! Not allowed!

    Arraying

    I have built a pipe rack that has an array in it for adding support members and with that it adds rods for the additional members but i have ran into an issue to where the rods are all tied to the same length command and i need them to be able to stretch individually due to some may go to the deck and others may go to a piece of strut under another element. Can anyone help me out here.

  2.    #2
    Senior Member
    Join Date
    August 19, 2011
    Location
    New Hampshire
    Posts
    524
    Current Local Time
    06:23 AM

    Not allowed! Not allowed!
    What are the minimum and maximum number of support members? Array will likely not be the way to go if you need individual length adjustments.

  3.    #3
    Junior Member
    Join Date
    September 28, 2017
    Posts
    26
    Current Local Time
    06:23 AM

    Not allowed! Not allowed!
    There is no min or max. It all depends on how long we want to make it and also spacing needed per spec on supports.

  4.    #4
    Moderator Robin Deurloo's Avatar
    Join Date
    July 7, 2011
    Location
    Rotterdam, Holland
    Posts
    1,685
    Current Local Time
    12:23 PM

    Not allowed! Not allowed!
    Nope array makes the item in the array a group, meaning they are all the same.
    Think you need to figure out another way.

  5.    #5
    Forum Addict elton williams's Avatar
    Join Date
    December 7, 2010
    Location
    Gold Coast
    Posts
    2,822
    Current Local Time
    08:23 PM

    Not allowed! Not allowed!
    You can cut arrayed group members (of cuttable categories) with voids, but that could be a lot of extra work -and upkeep- depending on your needs.

  6.    #6
    Member
    Join Date
    December 11, 2010
    Location
    Astana
    Posts
    249
    Current Local Time
    04:23 PM

    Not allowed! Not allowed!
    Can you attach a sketch or something to make it clearer what you want to get?
    Last edited by Nurlan; September 17th, 2020 at 04:29 AM.

Similar Threads

  1. Trouble with arraying around a curved surface
    By Axeman89 in forum Architecture and General Revit Questions
    Replies: 11
    Last Post: August 21st, 2016, 01:17 AM
  2. Arraying lamp posts along a windy path
    By Lox in forum Architecture and General Revit Questions
    Replies: 7
    Last Post: August 12th, 2014, 07:44 PM
  3. Creating a void and arraying it with spaces
    By domsib in forum MEP - Family Creation
    Replies: 1
    Last Post: November 21st, 2013, 07:53 PM
  4. Workflow - Arraying Connectors
    By Randy_CaS in forum MEP - Family Creation
    Replies: 15
    Last Post: February 1st, 2012, 12:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •